is recommended. Equipment operators should also routinely inspect for proper ground connections.
Q: How can I inspect and maintain my wire feeder?
A: Periodically inspect the electrode wire drive rolls. If dirty, remove the drive rolls and clean with a wire brush. Deformed drive rolls should be replaced. Drive rolls should be changed, adjusted or cleaned only when the wire feeder is shut off. In addition, check the inlet and outlet guides and
replace if they are deformed from wire wear. Remember that when power is applied to a wire feeder, fingers should be kept away from the drive roll area.
Q: What are some important electrode safety considerations?
A: Welding power sources for use with MIG and TIG welding normally are equipped with devices that permit on/off control of the welding power output. If so, the electrode becomes electrically hot when the power source switch is ON and the welding gun switch is closed. Never touch the electrode wire or
any conducting object in contact with the electrode circuit, unless the welding power source is off. Welding power sources used for shielded metal arc welding (SMAW or Stick welding) may not be equipped with welding power output on/off control devices. With such equipment, the electrode is
electrically hot when the power switch is turned ON.
Q: How should I store my gas cylinders?
A: Cylinders should be securely fastened at all times. Chains are usually used to secure a cylinder to a wall or cylinder cart. When moving or storing a cylinder, a threaded protector cap must be fastened to the top of the cylinder. This protects the valve system should it be bumped or dropped. Cylinders
should not be stored or used in a horizontal position. This is because some cylinders contain a liquid wh
Страницы: << < 1 | 2 | 3 > >>